Recent Jobs For Sterling Pool Service

January 6, 2017 | Sachse, TX

The owner went here the same day to address the issue. He had to replace the water by-pass assembly in order to stop the leak.

December 16, 2016 | Plano, TX

Our owner went out to investigate and found that the computer valve actuator was bad and needed to be replaced. After this, all of her problems were over.

December 14, 2016 | Dallas, TX

Our owner went to her house to diagnose the problem. He had to replace the filter tank clamp assembly to stop her DE filter from leaking.

December 14, 2016 | Dallas, TX

Our owner went to inspect his equipment and found the heater heat exchanger and gaskets were bad, the pool pump was bad and there was a leaky Jandy valve. All of these problem parts were replaced and the leaks stopped.

December 14, 2016 | Plano, TX

Our owner went to investigate the problem and found that his time clock for the pump and Polaris pump weren't working. Our owner spoke with Wally about this and Wally said he's worried about the equipment turning on automatically with the up-coming freezing weather. We ended up installing a dual ...

December 13, 2016 | Plano, TX

Our owner went over and replaced his pool equipment timer and freeze guard mechanism.

December 13, 2016 | Plano, TX

Our tech went to see about her problem and found the filter pressure to be very high. He performed a filter clean service and found that four grids needed to be replaced. After replacing the grids and adding DE to the skimmer, the filter worked without any debris or DE ...

December 12, 2016 | Dallas, TX

Our owner proposed to her that it can be repaired for a couple of hundred dollars less than a new one but that the work/parts wouldn't be warrantied as long a new one would be. She chose to have a new pool pump motor installed. All is good with ...

December 9, 2016 | Allen, TX

Our owner went to fix the problem but was only able to set the valves so the spa won't drain. We have submitted a bid to install a new spa return valve actuator.

December 7, 2016 | Plano, TX

The owner went to diagnose the problem and found a leak at the pipe going into the pump. He had to replace a section of piping and the pump basket to stop the gurgling noise.

December 7, 2016 | Plano, TX

We started this repair by first installing a new 400,000 BTU Heater, which included all gas plumbing, new electrical wiring from the heater to the timer and included haul-off of the old heater. Then we installed a new 2HP Pentair Whisperflo pool pump which included all of the related wiring and ...

December 7, 2016 | Murphy, TX

Our owner went to see about this problem. He found the filter pressure was very high, over 35 psi. He took apart the filter to clean it since regular backwashing wouldn't help this. Upon doing this, he found busted parts and had to replace the top manifold. The grids were in ...

December 7, 2016 | Plano, TX

Upon taking the filter apart, our technician found the top and bottom manifold were broken. After cleaning each grid individually, he replaced both top and bottom filter manifolds. As well, he replaced the pool clamp band and O-ring. Once he was finished, the pool started operating the right way.

December 6, 2016 | Plano, TX

We promptly went to his house to inspect the problem. Our owner found the clamp to be worn out and the filter tank O-ring was worn out as well. He replaced the filter tank clamp and tank O-ring then the gushing leak stopped.

December 3, 2016 | Wylie, TX

We submitted a bid to re-plaster, re-tile, replace coping stones, re-surface the deck and install new expansion strips (deco-seal). After several weeks of waiting, her insurance company finally approved the work to be done. She said that her pool has never looked so good after we finished.