Recent Jobs For Sterling Pool Service

September 7, 2016 | Plano, TX

We went to investigate and found it was the pool sweep pump that had a bad capacitor. It was replaced and she was able to set the timer again for it to run.

September 1, 2016 | Rowlett, TX

When we got there, we discovered that the diagnosis was correct. The pump was not running. So we installed a new 1.5-HP pool pump motor. Everything works well now.

August 29, 2016 | Sachse, TX

Our lead technician went to evaluate this noise. He had to replace the pool sweep pump motor, seal plate, impeller, and motor mount in order to stop the noise. After that, the pool worked properly.

August 18, 2016 | Dallas, TX

Our repair technician went there to diagnose the problem and had to replace the pool filter pump impellor, diffuser, seal, and O-ring to get it to run properly.

August 17, 2016 | Dallas, TX

Our owner went out to diagnose the problem and confirmed it was leaking water at the backwash line, which caused the pool to lose water. The leak was repaired and our customer was happy.

August 17, 2016 | Plano, TX

Our owner went out to investigate and found her chlorinator needs to be replaced. We had to unscrew the chlorinator from its base and replace all components with new parts.

July 27, 2016 | Dallas, TX

Our repair technician went out to evaluate the situation and found that the pool water level was too low to run the system. The skimmer wire doors also were stuck. Those problems were taken care of and the bubbles stopped.

July 25, 2016 | Plano, TX

Our owner went out to inspect and found it only needed a new capacitor. After that, it was alive!

July 18, 2016 | Allen, TX

We replaced the O-ring on the chlorinator base and secured the assembly. In addition, the customer asked about his booster pump leaking. There, we had to install a new seal, O-ring, and impeller on the pool sweep pump to fix the leak.

July 15, 2016 | Plano, TX

We replaced the pool pump capacitor, which is not a costly repair. That did the trick and the pool is back in proper working order.

July 15, 2016 | Plano, TX

Upon our arrival to evaluate, we found a filter clean was needed. After performing this service there were 2 grids and the manifold that we replaced. Once this was done started the system and added chlorine to the pool. It turned clear and blue in a few days.

July 13, 2016 | Dallas, TX

We found the filter had not been cleaned in some time and, indeed, the pool sweep timer was not working. The customer opted to do his own filter clean and we replaced the timer for the pool sweep.

July 13, 2016 | Garland, TX

We went out to evaluate their pool and submitted a bid for service the same day. After less than one hour of receiving our bid, they approved us for their weekly pool service.

July 12, 2016 | Dallas, TX

We installed a new 2HP pool pump motor. The systems now run, and sound, great.

July 12, 2016 | Rowlett, TX

We went to the house to evaluate his pool then emailed our bid for weekly pool service. The next afternoon they asked us, "When can we start?" We said, "At the beginning of next week." They've been happy with us since then.