Recent Jobs For Sterling Pool Service

October 31, 2016 | Plano, TX

We went out and found that it needed a new pool pump motor, seal, housing gasket and motor mount plate. As well we installed new cartridges in his cartridge filter then replaced three plugs in the plumbing from past leak detections and replaced O-rings in one Jandy valve.

October 26, 2016 | Frisco, TX

Our owner went to evaluate the issues and had to replace a seal in the pool pump, replace the DE Filter bulkhead fitting, bulkhead O-ring, tank O-ring and performed a filter clean service. After this, all the leaks were stopped and the pool ran as it should.

October 26, 2016 | Plano, TX

Our technician went to her house and replaced the discharge hose and fitting on the Polaris booster pump. No more leaks!

October 22, 2016 | Wylie, TX

Our owner checked this problem out. He wound up installing a 3/4 uniseal motor, a seal plate, and the related plumbing to stop the noise from her booster pump. She is very pleased now and will use us again for repairs when needed.

October 19, 2016 | Plano, TX

Our owner went there to see about her problem and found it to be several. In order to fix them, he replaced the pool filter lower housing, replaced the backwash valve piston assembly, re-plumbed the pool pump discharge, and re-plumbed two air blower pipes. There are now no more leaks ...

October 14, 2016 | Richardson, TX

Our technician went out to inspect and found that the filter pressure was extremely high indicating a filter clean is needed. He performed a filter clean service and their pool re-gained circulation and became clear and blue again.

October 12, 2016 | Plano, TX

Our technician went out to investigate this problem and found that pool pump lid O-ring is bad and needs to be replaced. He replaced the pool pump lid O-ring and the pool pump was able to catch prime and run normally.

October 11, 2016 | Murphy, TX

We went to look at the situation and saw the broken pipe. We repaired it and the pool is running well again.

October 11, 2016 | Garland, TX

Our owner went to see why he's losing water. He found a leak inside the backwash valve and repaired it. Now, the pool is holding water the way it should.

October 10, 2016 | Garland, TX

He brought it in to be looked at and after our owner evaluated it he found it needed to be replaced. She approved the work and when we went to replace it at her house he found the pool sweep pump capacitor was bad as well. He replaced that after ...

October 6, 2016 | Frisco, TX

Our technician went to look at it and had to install a new pool pump motor, seal, gasket, impeller, diffuser, and motor mount plate. It's all working just fine now.

October 6, 2016 | Plano, TX

Our owner went out the same day to investigate and found a bad capacitor. He had to replace the capacitor then the pool pump motor ran fine.

October 6, 2016 | Wylie, TX

Our owner went out to check on the problem and found it in pretty bad shape. We had to remove and replace the pool pump timer/freeze-guard mechanism to get it all to work right again.

October 3, 2016 | Garland, TX

We went to the house to diagnose and had to replace O-rings on the filter in order to stop the leaking. After replacing them all worked smoothly.

October 3, 2016 | Sachse, TX

We went out and ended up re-plumbing the broken backwash valve piping and replaced the backwash valve internal assembly. She was happy the leaks are repaired.