Recent Jobs For Sterling Pool Service

July 11, 2016 | Wylie, TX

We replaced the backwash valve internal assembly, O-rings on the pool pump, and replaced a filter gauge. After that, everything worked well.

June 17, 2016 | Sachse, TX

Our lead technician went to her house to evaluate these issues. He found that the leak at the bottom of the backwash valve was causing all of the water loss. He had an extra one on his truck so he replaced that part on the spot. Her Polaris also needed ...

June 16, 2016 | Sachse, TX

One of our technicians went to her house to assess the situation. It turned out to be an easy fix. The filter pressure was well over 30 lbs, which was preventing water flow inside her pools DE filter. He performed a filter clean service for her and that fixed all of ...

June 13, 2016 | Plano, TX

We went to look at it and found all they needed was a filter clean service done. After doing the filter clean, everything worked properly.

June 9, 2016 | Dallas, TX

We installed a new 3/4 Uniseal motor for the pool sweep. All equipment began working perfectly.

June 9, 2016 | Plano, TX

Our owner went to see about the problem and had to replace the booster pump's impeller and repair plumbing leaks. No more burning smell after this repair and the automatic pool sweep runs great.

June 8, 2016 | Dallas, TX

We went out to check and noticed that only the pool pump housing and gaskets needed to be replaced. After that was done, the leak stopped.

May 23, 2016 | Wylie, TX

We installed a new 48sqft Pentair DE Filter, a new 2hp spa air blower, a new 400,000 BTU Pool heater, a new computer valve actuator for an automated system and replaced a check valve.

May 19, 2016 | Plano, TX

We went to his house to check out this leak and found the filter multi-port valve is the leaking. Our owner had to change the full multi-port rotary valve out with a new one.

May 18, 2016 | Sachse, TX

We installed a new 60sf Pentair filter and backwash valve, along with the associated plumbing. The pool required two trips to balance the chemicals and clean it. We replaced the pump basket and pump lid, and also repaired the salt system flow switch. After that, everything was back in peak ...

May 16, 2016 | Wylie, TX

The pool equipment was replaced and the system works as intended.

May 16, 2016 | Plano, TX

We did a filter clean and had to replace all grids. The backwash valve was repaired. The customer elected to clean their pool and rebalance the chemicals themselves.

May 9, 2016 | Dallas, TX

Our owner went to investigate and she asked him to replace whatever was needed on the pool filter pump and pool sweep booster pump to be sure there are no more leaks. He ended up having to replace the seal and gasket in the pool sweep booster pump and an ...

May 5, 2016 | Carrollton, TX

The owner went to investigate and found that the pool sweep wall screen was clogged and that the husband had bought the wrong automatic pool cleaner sweep for his pool. Once they acquired the correct sweep, all was good.

May 3, 2016 | Allen, TX

We went out to evaluate and found that he needs a new On-Off switch installed, followed by an evaluation of the heater's performance. In addition, the Polaris is worn out and there are stones that need to be sealed. The customer was grateful for our time and expertise.