Recent Jobs For Sterling Pool Service

February 21, 2017 | Garland, TX

After looking at the pool, we gave them two options. One would take five trips after the filter was cleaned and may require more filter cleans, as well as rebalancing the chemicals. The second option was to drain and clean the pool, clean the filter, and rebalance the chemicals. However, ...

February 14, 2017 | Sachse, TX

The owner of the company went to her house to check out the problems. He found that the filter pressure was almost at 40 lbs of pressure and saw the numerous leaks at the pool equipment. To get the filter pressure under control, he had to perform a filter clean service. ...

February 13, 2017 | Richardson, TX

We found the skimmer needed to be replaced, which is a common problem with pools. He approved a written bid and we replaced the skimmer.

February 2, 2017 | Wylie, TX

Our owner went to investigate the issue. He started with the filter, found that it needed to be cleaned very badly because backwashing the filter alone was doing nothing. Upon cleaning the filter he found two grids that were bad, causing media to blow back into the pool from the ...

January 27, 2017 | Garland, TX

Our owner went to investigate the problems and found his heater needed to be replaced. We removed and replaced his old heater with a new Pentair 400,000 BTU pool and spa heater, which included plumbing, gas piping as needed, electrical, check valve and hauled off the old heater.

January 26, 2017 | Sachse, TX

We assumed the duties of providing after-care for his freshly plastered pool for two weeks. After our service was finished, he couldn't thank us enough for ensuring his pool plaster cured properly and helping his investment pay off.

January 24, 2017 | Allen, TX

Our technician went to investigate his problem. He replaced the Jandy valve diverter and caps, it helped some bud didn't solve the problem. We had to go back out to his house at a later date and our tech. replaced the check valve internals on the spa waterfall plumbing at ...

January 24, 2017 | Sachse, TX

Our owner went to investigate their problem and found a couple of leaks at the pump discharge pipe coming out of the top of the pump and at the filter. He had to re-plumb the pool pump discharge pipe and replaced the bulkhead nut, sleeves, and related plumbing.

January 20, 2017 | Wylie, TX

We offered to repair it or replace it and she chose to replace the pool sweep with a new Polaris model 280 in pool cleaner. She loves it.

January 19, 2017 | Dallas, TX

Our owner went to his house and found that a repair cannot be done to fix the noise. Instead, he had to install a new pool pump motor, seal and gasket.

January 19, 2017 | Arlington, TX

Our owner went to see about the noise and found multiple problems. He had to replace the pool pump impeller and impeller screw along with installing a new pool pump motor, seal, and O-ring. After making these repairs, his equipment ran without a sound.

January 17, 2017 | Plano, TX

We went to investigate these problems and found that her filter needs to have the sand changed and one of the skimmers is broken, which is causing the leak.

January 17, 2017 | Garland, TX

The owner went to investigate the problem and found the ball bearings to be the issue and non-repairable. He had to replace the Polaris booster pump to fix the issue.

January 12, 2017 | Allen, TX

Our owner went to verify the problem with his filter and had to replace the pool filter lid and repaired a leak at the pool filter drain plug. It is all running with no leaks now.

January 12, 2017 | Dallas, TX

Upon arrival at Alan's home, we performed a leak detection of the swimming pool and found the skimmer was leaking. We repaired the leak at the skimmer and the pool stopped losing water.