Recent Jobs For Sterling Pool Service

March 30, 2017 | Dallas, TX

Upon arrival, we confirmed Tim's opinion. The swimming pool heater had a broken rear header and header gaskets. We replaced both and the pool worked perfectly.

March 29, 2017 | Wylie, TX

We cut the tops from the deck expansion strips and installed flexible joint material. We replaced the expansion joint between the coping and deck. We installed a new 425 ft.² Hayward cartridge filter. And we installed a new chlorinator lid and O-ring. After doing that, the pool was up and operational ...

March 27, 2017 | Wylie, TX

We agreed to do the remodel. She went to standard white plaster and had the tile repaired. The Deco seal and deck strips also needed to be replaced. Her tile and coping work were no longer available, so repairing them was not an option. Replacement was necessary.

March 20, 2017 | Murphy, TX

We repaired the pool ozonator but the pool was losing water. After a leak detection at the pool and spa, we found two leaks in the swimming pool skimmer throat's that needed to be reset and sealed. After doing that, all worked well.

March 17, 2017 | Wylie, TX

Our owner submitted a bid for repairs and replacement and the customer opted for replacement. We custom fit the new Polaris to his pool and that made his wife very happy with us.

March 17, 2017 | Dallas, TX

The owner of the company went to her rental property to evaluate the problems. He found that the pool light GFI needed to be changed out and necessary wire/conduit plus a new circuit breaker. Her pool timer was shot, completely dysfunctional. It could not be repaired so she opted ...

March 16, 2017 | Wylie, TX

We performed a structural and plumbing leak detection at the pool and spa. Both skimmers were broken and there was a leak in the pool return and a leak in the spa return.

March 14, 2017 | Wylie, TX

We found the concrete pad had to be replaced and then this area had to be dug out to pour a new concrete pad. Then we would reset the swimming pool equipment and re-plumb as needed.

March 13, 2017 | Plano, TX

The owner went to the house to investigate these issues and found an array of problems. He had to replace the seal and O-ring in the pool pump, replaced the pool pump motor, the seal plate, the impeller (not the housing), the pool pump lid, pump O-ring and replaced the ...

March 8, 2017 | Murphy, TX

They chose to clean it up and try to find a way to stop the ducks from landing in their backyard. Ducks may be cute, but they are a serious health problem to swimming pools.

March 7, 2017 | Plano, TX

Our technician went out to disassemble her pool pump and found no problems with it. He then went to the DE filter to check for problems. The filter was packed full of dirt and needed to be cleaned. He did this and it still didn't fully help. Further investigating found ...

March 3, 2017 | Wylie, TX

We removed and replaced the expansion joint between the pool coping and deck. We also cut the tops off of the plastic expansion strips and installed the same expansion joint material as between the coping and deck. We also resealed the pool deck with two coats of cool deck sealer ...

March 2, 2017 | Rowlett, TX

Our lead technician was sent to his house to fix the problem. He found that the pump motor, seal, gasket, and diffuser needed to be replaced. After this was approved and completed, his pool pump motor worked like brand new.

February 23, 2017 | Richardson, TX

Our owner went to his house to look into this problem. He had to perform a filter clean service first to check for any damage to the internal parts. He found that every grid in the filter had gone bad somehow, he found several tears and holes on all of ...

February 22, 2017 | Plano, TX

The lead technician/owner went to his home for measurements and to assess the condition. It was all in need of some TLC. Craig approved a bid to replace the tile, install flagstone coping around the pool's edge, replace the dec-o-seal (mastic), and re-plaster the pool with Diamond Bright Tahoe ...