Recent Jobs For Sterling Pool Service

January 19, 2016 | Plano, TX

Our owner went out and found the timers are set incorrectly and checked the freeze guard. He set the timers correctly and replaced the seal, impeller & O-ring on the pool sweep pump.

January 14, 2016 | Wylie, TX

He called to say their pool pump motor is out. We were able to go the same day and gave a bid for repair. It was approved the same day and work done the next. We ended up installing a new pool pump motor, seal and O-rings. No problems have ...

January 13, 2016 | Plano, TX

Patrick had used our company several times last year. Now, he was very concerned about the impact of freezing weather on a pool pump that was not running. After an inspection of the equipment, we repaired a bad wire and replaced a broken conduit fitting. That allowed us to get ...

January 7, 2016 | Plano, TX

When we visited the homeowner's house, we discovered that his pool pump motor was 12-13 years old. We ended up installing a new motor, seal, and gaskets. That corrected the problem.

January 7, 2016 | Plano, TX

We got there and found a couple of more issues than just the pump not working. We installed a new pool pump motor, seal and O-ring on the pool pump. We also cleaned the filter and replaced the backwash valve internals. The pool cleaning, they said, can wait until the ...

January 6, 2016 | Allen, TX

We first met this couple in 2006 while working under the terms of their home warranty. The warranty expired years ago, but they still contact us for their pool equipment issues. This time, they called because the pump stopped working. We did repairs and got their system running again quickly.

January 6, 2016 | Richardson, TX

The customer called to say that his dog had chewed up the Polaris 280 and hose. He requested a bid with two options: repair or replace. He chose to replace the unit and keep plenty of dog treats on hand.

January 4, 2016 | Rowlett, TX

Because of the tornado, our technicians had to take on the task of cleaning the debris out Norm's pool. There were shingles, siding, trim, nails, screws, glass, dirt, leaves, limbs, twigs and all kinds of dead insects in the pool. The homeowners were very surprised that the pool could be ...

December 23, 2015 | Wylie, TX

After checking out the situation, our technicians installed a new pool pump with the necessary plumbing, as well a dual time clock with freeze guard. A couple of weeks later, she called to report that her pool sweep wasn’t working even though the sweep pump runs. Eventually, we replaced ...

December 15, 2015 | Sachse, TX

When we arrived, we found the skimmer lines and pool pump were clogged with debris. We blew out the lines, replaced a skimmer basket and a replaced a bad lid o-ring.

November 17, 2015 | Plano, TX

Typically, the removal process for this involves draining the pool, power-washing the walls and chlorine-washing the walls in order to kill the algae. We thought a specialty treatment might take care of this instead. We put this in the pool skimmer, cleaned the pool, did a filter clean, and adjusted ...

November 4, 2015 | Dallas, TX

We found the backwash valve was spewing water. We replaced the entire backwash valve with related plumbing, which solved the problem.

October 16, 2015 | Sachse, TX

Our owner went to his house to investigate this problem. He found that a leak detection needed to be done because there were zero visible leaks above ground and no wet areas in the yard that would suggest broken pipes underground. After the leak detection was done, we found that ...

September 14, 2015 | Murphy, TX

Upon inspection, we saw the Polaris pump had developed a major leak and needed to be replaced.  We replaced the pump and everything worked properly.

August 3, 2015 | Sachse, TX

We replaced a seal and gasket in the pool pump and the bubbles stopped.