A Native Pool Service Company
Most Pool Service Starting At
$185.00 + tax
Recent Jobs For Sterling Pool Service
July 12, 2017 | Plano, TX
Our pool cleaning technician reported there was a pinhole leak in the face plate of the booster pump. We installed a new pool sweep with a plumbing kit and everything is now working fine.
July 12, 2017 | Garland, TX
Our crew took a look and found it was only a minor repair of a leak on the Polaris pump.
July 9, 2017 | Sachse, TX
We vacuumed the pool and spa and adjusted the chlorine level. All that was wrong with the pool sweep was that it needed a wall fitting. The heater had to be replaced. We installed a repack 400,000 BTU heater including plumbing, gas, and electrical.
July 8, 2017 | Allen, TX
Our technician installed a new Jandy aqua link computer with wireless remote. Charlie has been pleased with the upgrade.
July 7, 2017 | Sachse, TX
We did these repairs that the customer requested, and also discovered the need to replace the filter gauge and install a new pool cleaner plumbing kit on the sweep. After making those repairs, the pool was back in top working condition.
July 7, 2017 | Garland, TX
The company owner went to his house and found that the breakers needed to be reset. After that, everything started to run properly.
July 5, 2017 | Sachse, TX
We installed a Polaris 280 in-pool cleaner. It was custom-fit to the pool design. Even with the new models that are available, the Polaris 280 is the only model we recommend because it has a larger throat to pick up leaves and a larger bag for holding debris. In addition, the drive ...
July 5, 2017 | Plano, TX
We found the problem was that the O-rings used for suction valves had to be replaced. We replaced them and the pool worked well.
July 4, 2017 | Dallas, TX
We installed a new Polaris 280 in the pool cleaner. This has a larger throat to pick up leaves and the bag is also larger than the bag on other models. This got his pool equipment working at peak efficience once again.
July 3, 2017 | Allen, TX
Our crew discovered the computer had two bad relays and replaced both of them. After that, the pool computer has worked as intended.
July 1, 2017 | Wylie, TX
After looking at the pool and spa, we discovered the plaster was also hollow. This contributed to the crack. We didn't recommend she do anything at this time because the pool was not losing water.
June 30, 2017 | Dallas, TX
We re-plastered the pool with standard white plaster and provided new plaster care for the next 10 days.
June 29, 2017 | Dallas, TX
When we arrived, we found the current timers, freeze guard boxes, and internal assemblies were worn and rusty. We installed a new door timer with freeze guard in one enclosure.
June 23, 2017 | Garland, TX
The heater had rusted and there were rat nests in it. We installed a new Ray pack 400,000 BTU heater that included plumbing, gas, and electrical.
Total: 409
